How to build phone using a CDP'd number
How to build phone using a CDP'd number
(OP)
I'm very new to this...
I'm trying to build a new phone using a CDP'd DN and keep getting the SCH0375 error.
I just need to know how to build a 3904 using the CDP'd DN.
Please help lol
I'm trying to build a new phone using a CDP'd DN and keep getting the SCH0375 error.
I just need to know how to build a 3904 using the CDP'd DN.
Please help lol
RE: How to build phone using a CDP'd number
Are you doing this via a command line interface?
Firebird Scrambler
Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer
Website = http://somertel.net
linkedin
RE: How to build phone using a CDP'd number
There is a department using this CDP'd DN as their main line.
They want me to add another phone with this DN and it's many rollovers.
So I would go to ld 87 and remove the cdp?
Then go into ld 20 to build the phone and then add the cdp back in ld 87?
I don't want to screw this whole department up LOL
RE: How to build phone using a CDP'd number
Yes, it's LD 87. If I was you, then I would print out the CDP details first. It will be something like..
REQ. PRT
TYPE CDP
CUST 0
CDP xxxx. (Number to be checked)
It should print out the CDP details.
Then do ..
REQ. OUT
TYPE CDP
CUST 0
CDP xxxx
I haven't touched CS1000 for many years,so some of the prompts might be wrong. I think you might need need to specify the CDP type such as TSC or DSC etc.
Once the CDP number has been removed, go to LD 10, 11 or 20 to add in a phone or make a change to a set etc.
LD 20
REQ: NEW
TYPE xxxx (e.g 3904 etc)
CUST 0
And carry on with the set, or you can use the "CPY" command instead of "NEW" to copy from an existing phone.
Firebird Scrambler
Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer
Website = http://somertel.net
linkedin
RE: How to build phone using a CDP'd number