Hipath 3800 configuration
Hipath 3800 configuration
(OP)
Hello everybody!!
My name is R. Lhemoz, I'm a telecommunications technician and I have a question about a HiPath 3800 configuration.
I have 2 analogue lines arriving in a TM2LP (line 1 7801 and line 2 7802) and 3 KS telephone sets (extension 100, 101 and 102) in a SLMOP2.
The settings I want are:
1° Extension 100 can only make internal calls (between extensions);
2° Extension 101 will only be able to make external calls through line 2 (7802), taking this line through zero ("0").
3° Extension 102 will only be able to make external calls through line 1 (7801), picking up this line through ("0") zero.
Could someone help me with this configuration?
My name is R. Lhemoz, I'm a telecommunications technician and I have a question about a HiPath 3800 configuration.
I have 2 analogue lines arriving in a TM2LP (line 1 7801 and line 2 7802) and 3 KS telephone sets (extension 100, 101 and 102) in a SLMOP2.
The settings I want are:
1° Extension 100 can only make internal calls (between extensions);
2° Extension 101 will only be able to make external calls through line 2 (7802), taking this line through zero ("0").
3° Extension 102 will only be able to make external calls through line 1 (7801), picking up this line through ("0") zero.
Could someone help me with this configuration?
RE: Hipath 3800 configuration
Check these:
Settings -> Classes of service -> Station (Day and Night)
Settings -> Classes of service -> Group Assignment -> CON Matrix
Settings -> Least cost routing -> Dial plan
I attached offline.kds.
This is just a rough example and most likely it needs some corrections.
RE: Hipath 3800 configuration
RE: Hipath 3800 configuration
Now I'm going to adjust the numbering plan to make out-of-state calls:
"0" (pull line) + 041 "operator number" + 011 "DDD - status code" + "phone number" 3211-6655
I am from Brazil.
RE: Hipath 3800 configuration