Hipath 4000 V3 - Duplex - Board SF2X8
Hipath 4000 V3 - Duplex - Board SF2X8
(OP)
Hi,
I have a system with a hipath 4000 v3 duplex with a sf2x8 card.
I have identified some problems with this board (sf2x8), so i want to connect directly customer lan, iptrunk, sip and hfa to the switch.
I have a connection with a dscxl board with dot dash that connects to sf2x8 board.
my question is how should i make the connection between the remaining dscxl boards?
Thank you.
I have a system with a hipath 4000 v3 duplex with a sf2x8 card.
I have identified some problems with this board (sf2x8), so i want to connect directly customer lan, iptrunk, sip and hfa to the switch.
I have a connection with a dscxl board with dot dash that connects to sf2x8 board.
my question is how should i make the connection between the remaining dscxl boards?
Thank you.
RE: Hipath 4000 V3 - Duplex - Board SF2X8
Customer LAN can go into the Bottom Processor (Dash Dot) into the socket marked Customer
IP trunk goes into an IP Card like STMI
RE: Hipath 4000 V3 - Duplex - Board SF2X8
For example yesterday I disconnected and plugged the cable and iptrunk was working.
I suspected sf2x8 because I have 3 stmi2 (HFA, IPTRUNK and SIP configuration) connected at this board.
Which connects to a single port on the switch andI want to have a good management for each board in the switch.
RE: Hipath 4000 V3 - Duplex - Board SF2X8
There are (as you know) 8 customer LAN ports on that card.
However all it is - is an IP Switch.
Plug the Customer LAN into an IP switch like a Netgear or similar - plug the ADS Processor (Bottom Processor) Customer socket into the same IP switch.
Then also plug your STMI cards into that IP switch.