NT1R20AB OPS Line Card and Disconnect Supervision
NT1R20AB OPS Line Card and Disconnect Supervision
(OP)
I have a NT1R20AB OPS Station card and am trying to get hook flash disconnect supervision working. I *think* I have the TNs configured properly with the most important bit being FTR ISP. Below is an example TN.
However, what I am finding is that disconnect supervision is only working on calls received by the station and not on calls placed by the station. I've had this same configuration via a Lineside T1 card connected to a channel bank and disconnect supervision worked with placed and received calls fine. I did try removing FTR OSP in case battery reversal disconnect supervision was conflicting with hook flash disconnect supervision but that did not make any difference.
I should also mention that these TNs were MOVed from a Lineside T1 to the OPS Line Card. Just in case something might've been in a funky state I went as far as power cycling the system...no change. I have not tried OUTing and re-creating a TN.
I'm assuming the OPS line card will work the same as the Lineside T1, but maybe I have something misconfigured...or my assumption is bad!
Any ideas?
CODE
DES MODL21 TN 004 0 00 00 TYPE 500 CDEN DD CUST 0 ERL 00000 WRLS NO DN 3311 0 MARP CPND NAME A DESK M1 ANALOG 1 XPLN 18 DISPLAY_FMT FIRST,LAST AST NO IAPG 0 HUNT TGAR 1 LDN NO NCOS 0 SGRP 0 RNPG 1 LNRS 16 XLST SCI 0 CLS UNR DTN FBD XFA WTA THFA FND HTD OPS HPR XRA AGRD CWA (ACTIV) SWA PUA MWD RMMD SMWD LPD XHD SLKD CCSA-CSI LNA TVD CFTD SFD MRD C6D CNID CLBD AUTU ICDD CDMD LLCN EHTD MCTD GPUA DPUD CFXD ARHD OVDD AGTD CLTD LDTD ASCD SDND MBXA CPFA CPTA DDGA NAMA MIND MCRA EXR0 LOL ABDD CFHD DNDY DNO3 CWND USMD USRD BNRD OCBD RTDD RBDD RBHD FAXD CNUA CNAA PGND FTTU CDMR MCDD T87D PKCH MPTD PLEV 02 AACS NO MLWU_LANG 0 FTR OSP 1 FTR ISP 75 TIMP 600 BIMP 3CM2 DATE 8 OCT 2022
However, what I am finding is that disconnect supervision is only working on calls received by the station and not on calls placed by the station. I've had this same configuration via a Lineside T1 card connected to a channel bank and disconnect supervision worked with placed and received calls fine. I did try removing FTR OSP in case battery reversal disconnect supervision was conflicting with hook flash disconnect supervision but that did not make any difference.
I should also mention that these TNs were MOVed from a Lineside T1 to the OPS Line Card. Just in case something might've been in a funky state I went as far as power cycling the system...no change. I have not tried OUTing and re-creating a TN.
I'm assuming the OPS line card will work the same as the Lineside T1, but maybe I have something misconfigured...or my assumption is bad!
Any ideas?