Programming SL1100 MLT buttons to select a particular trunk line
Programming SL1100 MLT buttons to select a particular trunk line
(OP)
Hi,
Have SL1100 & two MLT 24 key.
One came "as is" & uses the 2 ISDN lines as normal. incoming & outgoing
I would like to pick up handset & press e.g. 3rd soft key & get the SIP line
The first 2 I guess are OEM line trunk 1 & 2
I should say currently because there is a fault on my ISDN lines and need to be able to choose SIP
Not programmed or set up for a few years so really can't remember much.
How do I set up that MLT to use SIP on pressing a soft key?
My 2nd MLT I have set up to ring in on my main isdn's line but outgoing is the SIP (single number)
I really cannot remember how I did that but it all works.
this one does not have access to the idsn lines so perhaps I could do that but not so important.
thanks I/A.
Have SL1100 & two MLT 24 key.
One came "as is" & uses the 2 ISDN lines as normal. incoming & outgoing
I would like to pick up handset & press e.g. 3rd soft key & get the SIP line
The first 2 I guess are OEM line trunk 1 & 2
I should say currently because there is a fault on my ISDN lines and need to be able to choose SIP
Not programmed or set up for a few years so really can't remember much.
How do I set up that MLT to use SIP on pressing a soft key?
My 2nd MLT I have set up to ring in on my main isdn's line but outgoing is the SIP (single number)
I really cannot remember how I did that but it all works.
this one does not have access to the idsn lines so perhaps I could do that but not so important.
thanks I/A.
RE: Programming SL1100 MLT buttons to select a particular trunk line
RE: Programming SL1100 MLT buttons to select a particular trunk line
The top 2, from the left, light up red when one or two lines are used.
This one I would like to be able to pick up & press a spare button & get the SIP line.
My 2nd MLT (SIP) I don't remember programming (but must have) lights up 2nd line, first button, green, when I pick up & 9 to outside.
This one also flashes the top 2 buttons if someone else is using the isdn trunk lines but I can't access those line but as I say not too worried about that, it just uses the SIP
I was just reading that somehow can set up a 2nd, outside line, number. e.g. 8 (instead of usual 9) & that will grab a specified truck. not got good instruction on that but that might be a easier & more universal solution.
Not too sure who to do that at the moment or which is easiest I think as short of time.
RE: Programming SL1100 MLT buttons to select a particular trunk line
RE: Programming SL1100 MLT buttons to select a particular trunk line
Thank you for your reply,
PC Pro,
Prefer to use PC Pro as much as possible but I guess need to use the MLT to program some features?
How do I assign a trunk number to the keys.
Is there is a manual or instructions? I could not find anything that had that sort of detail for programming the phones,
I have everything for the SL1100 itself.
RE: Programming SL1100 MLT buttons to select a particular trunk line
RE: Programming SL1100 MLT buttons to select a particular trunk line
Had a quick look at the manual,
I will work it out but does not seem immediately obvious how to program the trunk to a key.
Thanks again.
RE: Programming SL1100 MLT buttons to select a particular trunk line