RichTanner
Vendor
THe best way o clean the AAA battery contacts within the ACS processor. Much crud on he contacts from a battery leak.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
THe best way o clean the AAA batter
- Thread starter RichTanner
- Start date
- Status
There are holes with arrows in the case. Use a screwdriver to push on the tabs according to the arrows. This will release the case. Then you can clean the inside springs and the door slidey thing.
Dermis and feline can be divorced by manifold methods.*
*(Disclaimer for all advise given)--'Version Dependent'
Dermis and feline can be divorced by manifold methods.*
*(Disclaimer for all advise given)--'Version Dependent'
ZeroZeroOne
Systems Engineer
Use a weak acid like white vinegar to counteract the alkaline crud. Apply with a Q-Tip or other small applicator until it stops bubbling. Be careful not to get too much on the electronics or circuit board.
Use a soft brush, like an old tooth brush, to physically remove the residue.
Use a soft brush, like an old tooth brush, to physically remove the residue.
TouchToneTommy
Vendor
If you don't want to disassemble the module, try a "scratch brush"
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question