OneAccess One425
OneAccess One425
(OP)
Hey Guys,
Has anyone had any luck breaking into a OneAccess One425 and connecting it to a SIP Carrier other than Telstra in Australia?
Trying to get customers away from the Big T, a lot have purchased this OneAccess Box, and I was wanting to see whether we could use its BRI Interfaces to supply SIP to older PBX systems. However, all I can find online is sales information from Ekinops, and all the Telstra junk they put out.
From what I can gather, you need to have access to a web/server based interface (OneManage) that you create login credentials for the box to connect with a server, your SIP registers with the server, and creates a link to the OneAccess Box, the box then creates a link to the BRI ports and dumps the SIP traffic out as BRI.
Anyone with experience in these? or able to lead me down the yellow brick road to see the wizard so I can get this sorted.
As the moment, I don't believe what I want to complete is possible, but no harm in asking.
Has anyone had any luck breaking into a OneAccess One425 and connecting it to a SIP Carrier other than Telstra in Australia?
Trying to get customers away from the Big T, a lot have purchased this OneAccess Box, and I was wanting to see whether we could use its BRI Interfaces to supply SIP to older PBX systems. However, all I can find online is sales information from Ekinops, and all the Telstra junk they put out.
From what I can gather, you need to have access to a web/server based interface (OneManage) that you create login credentials for the box to connect with a server, your SIP registers with the server, and creates a link to the OneAccess Box, the box then creates a link to the BRI ports and dumps the SIP traffic out as BRI.
Anyone with experience in these? or able to lead me down the yellow brick road to see the wizard so I can get this sorted.
As the moment, I don't believe what I want to complete is possible, but no harm in asking.
RE: OneAccess One425
1. Once connected to the console of the device using OneAccess console cable. Press <ESCAPE>, then <CTRL>+Y and finally <CTRL>+N.
2. You will be prompted whether you want to factory reset the device. Type 'Y' for yes.
3. You will then be asked if you would like to reboot the router. Type 'Y' for yes.
4. After the factory reset you can no login via telnet using default IP on FastEthernet 0/0 on default IP 192.168.1.10
5. The default OneAccess username and password is admin/admin
Marv ccna
RE: OneAccess One425