CUCM SNMP Set Command
CUCM SNMP Set Command
(OP)
Hi All,
I'm trying to test an snmp alarms on our new CUCM Cluster. I have everything setup correctly in CUCM and I try to use the snmp set command in CLI. It is complaining about the dash in snmpset -c <community string> -v2c. Any suggestions or idea why this is not working?
Thanks
Jeremy
I'm trying to test an snmp alarms on our new CUCM Cluster. I have everything setup correctly in CUCM and I try to use the snmp set command in CLI. It is complaining about the dash in snmpset -c <community string> -v2c. Any suggestions or idea why this is not working?
Thanks
Jeremy
RE: CUCM SNMP Set Command
https://www.cisco.com/c/en/us/td/docs/voice_ip_com...
Hope this helps