Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Avaya ip office to 3cx integration
- Thread starter rsv23
- Start date
- Thread starter
- #6
- Thread starter
- #7
teletechman
Technical User
All we did was create a SIP trunk to the 3CX I did not do any programming in the 3CX. Then we had to create a short code access code to dial the trunk to the 3CX. I was pretty straight forward when I worked with the programmer on the 3CX, he had more programming in the 3CX because he could not create a wild card ICR he had to create individual ICRs for each user on his side to receive calls from the IPO.
Mike
Mike
- Thread starter
- #10
@teletechman the outbound calls from Avaya to 3CX working is already working however, outbound calls from 3CX to Avaya still not working.
Do I have to create inbound rules also in Avaya to allow inbound calls from 3CX even this is for internal calls only(extension to extension).
Do I have to create inbound rules also in Avaya to allow inbound calls from 3CX even this is for internal calls only(extension to extension).
TouchToneTommy
Vendor
I think you need an incoming call route for the SIP trunk's incoming group with just a period at the destination
Thanks guys that is more helpful. I don't have issues per say as I have not started the setup or testing as of yet.
We had tried to implement it and ran out of time and switched to a class 4 to the IPO. So now we have to set-up and test.
Thanks again.
We had tried to implement it and ran out of time and switched to a class 4 to the IPO. So now we have to set-up and test.
Thanks again.
- Thread starter
- #13
@TouchToneTommy thanks for the input. It is working fine now. internal calls are working on both systems now.
Next step is to allow 3CX to call external number using Avaya system when dialing prefix 6 + mobile number, it should use the avaya system to dial out. Please let me know if you also steps for this.
Next step is to allow 3CX to call external number using Avaya system when dialing prefix 6 + mobile number, it should use the avaya system to dial out. Please let me know if you also steps for this.
- Thread starter
- #14
- Thread starter
- #15
The 3CX system needs to send numbers to the IPO, including the digit to dial out (typically 9), so when the number hits the IPO it knows to dial out. In IPO world making one system dial out from another is very simple. I don't know 3CX to help with that side though.
The truth is just an excuse for lack of imagination.
The truth is just an excuse for lack of imagination.
- Status
