ipecs firmware upgrade

Question

ipecs firmware upgrade

ntue (TechnicalUser)

(OP)

19 Oct 20 03:59

Hi guys, i have 2 quick questions that i hope you may kindly assist me with.
1. Where do i download the ipecs firmware upgrade to change the version from the 1.0 to the latest version and may i also have the step by step upgrade process.
2. When it comes to the LDK50, how do i change the version of the extension card on the system slot without having to reset the system thereby losing all programming in the process.

Thank you in advance

martinhodge (Vendor) · Answer 1 · 2020-10-19 15:24:39

if you are on a very early mfrim you will need to go from version 1 to 5.5 then from that to 6.1 you have to follow a process .

can you claifiy what system you have here or are you talking about 2 different systems?

and change the version of the extension card ...... ?

and why would you lose programming by turning the system on and off .

if you have a battery fault on the ldk50 . you should be swapping the motherboard out for a new one with a working battery . if your good with a solverding iron u can do this your self

ntue (TechnicalUser) · Answer 2 · 2020-10-19 17:49:56

Hi. Thank you for your response. I have an ipecs system that is version 1.0 and i want to upgrade the firmware to the latest. what process do i follow and where do i get the firmware plus how do i go about it. on the second point i am talking about the ldk50 which has the old version of the extension card, the one that has a black switch. i want to put that one in and remove the new version card which has 2 white switches. since the pbx has already been configured with the new version card will it not need to be defaulted so that it automatically recognises the old version card? I do not want to lose the current configuration but just want to get the system to 'see' the card i will put in.

martinhodge (Vendor) · Answer 3 · 2020-10-27 15:29:23

you need to confirm exactly what ipecs system you have . as there is different software for different systems etc .

its not a straight forward upload and upgrade going from version 1 to version 5.5 .

you need to follow a set procedure . if done wrong you risk killing the system .

i would suggest contacting a local reseller with experience in upgrading the system .

and if i was doing it i would have a spare system in the boot as it has gone wrong on me sometimes and doesnt happen oftern . but it does happen from time to time .

im more than willing to share software . but you do this at your OWN risk . if you break it . throw it away and get another system or ideally a ucp .

Come Join Us!

Posting Guidelines

ipecs firmware upgrade