×
INTELLIGENT WORK FORUMS
FOR COMPUTER PROFESSIONALS

Log In

Come Join Us!

Are you a
Computer / IT professional?
Join Tek-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!
  • Students Click Here

*Tek-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

how to configure h.323 on emg800 and mg100:

how to configure h.323 on emg800 and mg100:

how to configure h.323 on emg800 and mg100:

(OP)
Please tell me how to configure h.323 on emg800 and mg100:


A : pabx(emg800) sit 1 : plan num 32xx. CO DID type, 3 groups, cos1, h323 only.(emg800)
B : pabx sit(mg100) 2 : plan num 33xx co did type, 3 group, cos1 , h323 only.(mg100)




Question 1.
On MG100 in H.323 ATTR incoming (362) [N], it was possible to register From IP Address = UNKNOWN at the same time in the necessary group of lines.
There is nothing like that on EMG800, is there an H.323 Incoming Routing Table (328) menu where you can specify only IP, can you put UNKNOWN here?

Question 2.
By configuring outgoing. Since before, I had experience with MG and a little with Lik, I will focus on them.

In MG, I did it: in CO Group Access Code (114), you specify CO Group Access Code, in CO Group Access Code (180), you specified the group necessary for Outgoing, that's all.
Or in MG, via Digit Conv Table (251 ~ 252), I configured the conversion of the dialing to the desired group.

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Tek-Tips Forums free from inappropriate posts.
The Tek-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Tek-Tips forums is a member-only feature.

Click Here to join Tek-Tips and talk with other members! Already a Member? Login

Close Box

Join Tek-Tips® Today!

Join your peers on the Internet's largest technical computer professional community.
It's easy to join and it's free.

Here's Why Members Love Tek-Tips Forums:

Register now while it's still free!

Already a member? Close this window and log in.

Join Us             Close