Had three working D100s on 8.1.63 control unit until the customer's IT department upgraded all the switches and created a VLAN for the voice. Changed IP addresses for the SIP dect lines on the control unit and logged into the bases and changed those addresses. Made sure there wasn't a D100.cfg file on the SD card and put the base units back on the network. No good. I can log into the bases on the network and I can log into the IP Office on the network with no problems. IT department says they have the ports that the bases are plugged into tagged for VLAN 100 which is correct. All of the 1616s are working fine and i can ping them from the IP Office System Status but I can't ping the D100s. Switches are Ubiquiti Edge24s. Any suggestions on what to tell the IT department to check in their switches? They aren't very helpful and Id rather not have to go through isolating these things off of the network because they're in outbuildings with no spare fiber strands.
Red Flag Submitted
Thank you for helping keep Tek-Tips Forums free from inappropriate posts. The Tek-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Tek-Tips forums is a member-only feature.