I was onsite yesterday and replaced a 50 and tried to minimize the downtime by copying and replacing the primary cabinet. The expansion cabinet was plugged in afterwards and today I found it's not being enabled by the main cabinet?? Do I have to reboot the main cabinet for it to be seen? I've tried disabling and re-enabling the expansion, but it just says enabling and the first port 501 says Unequipped and the 502-504 ports say disabled by user?? Reboot to fix it or is there some other way? I have to wait for a quiet time to reboot due to traffic at this time.
Red Flag Submitted
Thank you for helping keep Tek-Tips Forums free from inappropriate posts. The Tek-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Tek-Tips forums is a member-only feature.