Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Programming a MICS 7.1 with a Valcom 2006 Paging unit

Status
Not open for further replies.
datajockey123

datajockey123

Technical User
Joined
Aug 23, 2007
Messages
189
Location
CA
I have a car dealer that has 4 zones on a Valcom 2006. Recently the KSU was upgraded with 7.1 software and in doing so the programming for the zones was lost.
I have the hand sets programmed in to their respective zones i.e. Sales zone 1, Parts & Service zone 2, etc.
When I program the department button using F*3, choose a button and press F611 for zone 1 and continue on with the rest of the zones, F612, F613, F614 all I get is the sets in the group. I need to get the speakers in those respective departments to work as well.
Is it F621 and F622, to get zone speakers to work as well?
Thanks in advance for any suggestions
Datajockey123
 
Sort by date Sort by votes
Should be Feasture *3 631, 632, 633, 634 for both sets and speakers. If you want just the speakers mit's 621, 622, 623, 624.
 
Upvote 0 Downvote
I am not so sure the zone module is listening until the third digit (when doing set and speakers) is pressed?

So to
page zone 1 for sets and speakers might be F6311
page zone 2 for sets and speakers might be F6322
and so on

To page just the speakers for zone 1 then F621
To page just the speakers for zone 2 then F622
and so on



________________________________________
small-logo-sig.png


=----(((((((((()----=
Toronto, Canada

Add me to LinkedIN
 
Upvote 0 Downvote
I don't believe digital sets will send out DTMF on the page port. Are you sure the paging adapter is not connected to a CO port?

Marv ccna

 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

wardy5
  • Locked
  • Question Question
Additional speaker to paging system
Replies
4
Views
741
curlycord
curlycord
P
  • Locked
  • Question Question
Incoming calls go to dial tone on Nortel MICS-XC 7.0
Replies
11
Views
1K
curlycord
curlycord
telllman
  • Locked
  • Question Question
External Paging on Norstar MICS 12 32
Replies
5
Views
705
telllman
telllman
kpzan
  • Locked
  • Question Question
MICS 7.1 losing programming
Replies
9
Views
659
kpzan
kpzan
Michael OConnor
  • Locked
  • Question Question
DR4 to XC 7.1 too big of a jump?
Replies
5
Views
514
Michael OConnor
Michael OConnor

Part and Inventory Search

Sponsor

Back
Top