I have a Xerox 8400 that shows an error code 37,016,43 on startup. Elsewhere I found mention of a Service Bulletin SB636. Does anyone have this? Also I have the service manual and the first troubleshooting step says "1.Measure the 50 V power supply output. The test point is located on the power control board below the main board RAM DIMMs." I found TP840. TP841 & TP842 below and to the left of the RAM. Which one is the correct one? I believe it is 50 VDC, but I'm unsure. Does the check go from the test point to ground or what? Any help would be appreciated.
Red Flag Submitted
Thank you for helping keep Tek-Tips Forums free from inappropriate posts. The Tek-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Tek-Tips forums is a member-only feature.