ARS digits dialed configuration for 933 emergency test call
ARS digits dialed configuration for 933 emergency test call
(OP)
I'm using Flowroute with a Linksys by Cisco SPA8000 ATA, patched to a 3300 ICP + ASUs. In the Flowroute portal, on the E911 settings page, it states, "You can use 933 to make an E911 test call and verify the information that the emergency operator receives. Do not dial 911 to test your 911 service. Dialing 911 when there is no emergency may subject you to criminal penalties."
When I dial 9933 (9 for outside line + 933) from a Mitel 5215 IP phone, after a brief delay, I hear fast beep tones and it says INVALID on the display.
I changed SPA8000 dial plans for all lines and the trunks we use, to match 933. This made no difference. For the 3300, in System Administration > Automatic Route Selection (ARS) > ARS Digits Dialed Assignment, I added an entry for 933, like the one for 911:
Route Assignment for route number 9:
Digit Modification Assignment:
And finally, ARS Leading Digits Assignment:
Adding the 933 digits dialed assignment made no difference (still results in INVALID). Any ideas/suggestions?
Thank you!
When I dial 9933 (9 for outside line + 933) from a Mitel 5215 IP phone, after a brief delay, I hear fast beep tones and it says INVALID on the display.
I changed SPA8000 dial plans for all lines and the trunks we use, to match 933. This made no difference. For the 3300, in System Administration > Automatic Route Selection (ARS) > ARS Digits Dialed Assignment, I added an entry for 933, like the one for 911:
Route Assignment for route number 9:
Digit Modification Assignment:
And finally, ARS Leading Digits Assignment:
Adding the 933 digits dialed assignment made no difference (still results in INVALID). Any ideas/suggestions?
Thank you!
Talk To Other Members
RE: ARS digits dialed configuration for 933 emergency test call
Try removing <T01>9 from this form and the correct digits should be sent to line.
RE: ARS digits dialed configuration for 933 emergency test call
I notice you have not designated the Route as an emergency group, this will prevent the bells and whistles going off internally.
I suggest 411 as a replacement for 911
To make your Mod Digit more intuitive and understandable I would program as follows
With the Test Setting as above, you can dial 911 on the phone but the system will dial 411 for the test. (you can actually put any number you like in the test)
**********************************************
Any intelligent fool can make things bigger and more complex… It takes a touch of genius – and a lot of courage to move in the opposite direction.
RE: ARS digits dialed configuration for 933 emergency test call
@kwbMitel, helpful as always!
RE: ARS digits dialed configuration for 933 emergency test call
Designated consoles and IP sets can receive INTERNAL emergency notification that a call has taken place and advise of the source and time of the call. See Help files
**********************************************
Any intelligent fool can make things bigger and more complex… It takes a touch of genius – and a lot of courage to move in the opposite direction.