Sopho iS4000

<diovlm:chcalf;

UNIT OVERLAY-ID REFERENCE LOAD-STATUS CURR-AUTH

1 CHCALF - PER 1
EXECUTED
<chseau:1,?

ALLOWED: Allowed or not (0 = not allowed, 1 = allowed)
<chseau:1,1;
EXECUTED

Thanks a lot for your answer but didn't work; here is system answer:
+++ 0980-0001-0874-0001 2018-08-31 +5+ 11:29+ #0057 VDU010 >
<

EXECUTED
<chseau:1,1;
EXECUTED
<chcalf:?
Change call forwarding relation

CHCALF: <CF-TYPE>,[<ORIG-BSP-ID>sr][[,[<DEST-NUMBER>]]
[,[<UNIT>]][,[<CFDA-TIME>][,<CALL-ORIG-TYPE>]]];

If DEST-NUMBER is omitted, the call forwarding relation of the originator will
be erased.
Depending on the CF-TYPE, the originator should be a BSP-ID or a UNIT:

| CF-TYPE | ORIG-BSP-ID | UNIT |
|----------------+------------------------+-----------|
| 0, 1 and 8 | extension BSP-ID | - |
| 2 and 3 | group DNR (All groups) | - |
| 4 and 5 | ACD group DNR | - |
| 6, 7, 9 and 10 | - | UNIT |

For CF-TYPE 6, 7, 9 and 10 UNIT might only be omitted in a single unit system.

Layout for CF-TYPE = 0:
CHCALF: <CF-TYPE>,<ORIG-BSP-ID>sr[,<DEST-NUMBER>
[,,[<CFDA-TIME>][,[<CALL-ORIG-TYPE>]]];

Layout for CF-TYPE = 1..5 and 8:
CHCALF: <CF-TYPE>,<ORIG-BSP-ID>sr[,<DEST-NUMBER>][,,,[<CALL-ORIG-TYPE>]];

Layout for CF-TYPE = 6, 7, 9 and 10:
CHCALF: <CF-TYPE>,,[<DEST-NUMBER>],<UNIT>[,,[<CALL-ORIG-TYPE>]];
<chcalf:0,4005,16134597,,10;
Error 39: Invalid input data
REJECTED
<chcalf:0,4005,16134597,1,10,0;
Error 28: Illegal parameter combination
REJECTED
<^X
Message 211: Input line discarded
<^D
Message 235: END OF DIALOGUE # #0057 +++

hi
what is 16134597 ?
if Trunk access code verify with:
dinars:5;
if present


this command is correct
<chcalf:0,4005,16134597,,10;