Hi all i need help with a ipo 500v2 with v8.1.43 software. the system (has licencing in place) (192.168.1.230) needs to make a sip trunk to a freepbx (192.168.1.217 configured by someone else) on the local lan for sip calls. i have the sip line made and i believe that is good.( freepbx has no user/password and only allows the ip of the ipo in) i made a SC of code - 7N; feature Dial Tel number N; line group id 51:Sip .. also have made an ARS 7N; 7N;@192.168.1.217 dial 17 . the customer wants to keep using there bri lines while trying sip before committing to sip full time. the 7 code is meant so they can choose to dial via sip not isdn. i get silence while dialling a number and it never rings the endpoint of call. i have to use the freepbx as the main office (in another country) tried sip direct on the ipo and found it not so good and there support firm moved the sip to the freepbx and now all is good. I guess this is run of the mill stuff for most of you, but i did my ipo training about 10 years ago and have mainly just setup extensions and changed names etc since, and there was no sip training that i remember in that course. i dont have any system monitor logs as no-one knows the security password as its not the default and sysmon wont connect. will have to get a serial to usb lead so i can reset the passwords when im next there. System status can ping the freepbx ip address successfully. Help much appreciated thanks Stuart screen shots of the config
Red Flag Submitted
Thank you for helping keep Tek-Tips Forums free from inappropriate posts. The Tek-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Tek-Tips forums is a member-only feature.