Hi I have to replace a dual PRI card on my switch and my question is the PRI card has a daughter board on it. so the steps I need to do I'm just not sure what order to do them if it makes a difference. First disable the MSDL then the D channel then the loops. by the way I have 6 loops attached to this D-Channel if that makes a difference. once card is replaced I guess enable the MSDL then D-Channel then the loops??
Red Flag Submitted
Thank you for helping keep Tek-Tips Forums free from inappropriate posts. The Tek-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Tek-Tips forums is a member-only feature.