Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

IPO SE 9.1.7 Resiliency Questions (Not select edition)

Status
Not open for further replies.

NYSTECH

Vendor
Joined
May 9, 2008
Messages
1,534
Location
US
The setup is

IPO main server at main location
IPO backup server at remote location
IPO 500V2 at 3 other remote locations

The IP phones at each location register to their local IPO or Server.
Each site has 2 H323 SCN lines one going to primary and one going to secondary servers
SCN Resiliency options except Backs up my IP Dect phones are check for the H323 line back to main server.

With this setup the phones at remote locations should re register to Main server if the local PBX goes down.

My question would be can I also program the SCN Resiliency options on the h323 trunk going to backup server for each of these sites? If I can in case of faluer at local pbx which serevr would the IP phone register at? Is there a way to set like an agl list or can that be done using the 46xxxsettings file.




 
I think I found my answer

Activating resilience
You can activate resilience for users or extension configured on an expansion system to either a
Server Edition Primary or Server Edition Secondary only. You cannot split the resilience for an
expansion system between Server Edition Primary and Server Edition Secondary. You cannot
activate the resilience for an expansion system to another expansion system.

 
Another Question about Resilience Administration and this is for a system with a Primary and secondary server with 16 expansion systems.
By default in the Resilience Administration it appears that

Backup Primary Server IP Phones and HG on Secondary Server
Backup Secondary Server IP Phones on Primary Server Are checked
Update Expansion System IP phones backup setting are not checked.

I would guess that the last needs to be checked in order for the expansion systems IP phones backup to the Primary system correct. also once that is checked do I need to select the expansion systems that appear in box below that or by checking the above box will cover all expansion systems.
Any help is appreciated?



 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top