Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Hardware description of is3000 system.
- Thread starter leekawai
- Start date
the ALC board are used to connect anologue extensions
-ALC-Exx : 16 circuits (can be strapped for 8 circuits, thus emulating an ALC-A)
-ALC-F : 16 circuits
-ALC-G/GP/G(R) : 16 circuits
-ALC-GM :16 circuits (withoutthe daughter board ALC-GD)
-ALC-GM/GD : 32 circuits (withthe daughter board ALC-GD)
from ALC-G is possible load firmware for trasmission plan, otherwise set via dip switch
configure this board with correct data block ALC-E= 3205,ALC-G/F 3210, ALC-GM with daugther 321C, type 6, hw 255 .
bye
-ALC-Exx : 16 circuits (can be strapped for 8 circuits, thus emulating an ALC-A)
-ALC-F : 16 circuits
-ALC-G/GP/G(R) : 16 circuits
-ALC-GM :16 circuits (withoutthe daughter board ALC-GD)
-ALC-GM/GD : 32 circuits (withthe daughter board ALC-GD)
from ALC-G is possible load firmware for trasmission plan, otherwise set via dip switch
configure this board with correct data block ALC-E= 3205,ALC-G/F 3210, ALC-GM with daugther 321C, type 6, hw 255 .
bye
- Status
Similar threads
- Locked
- Question
- Locked
- Question