Log In

Come Join Us!

Are you a
Computer / IT professional?
Join Tek-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!

*Tek-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here



I am trying to get a 2811 to register with voip.ms, can't quite get it.
It does not even appear to be trying to register
This is what i have below

On the voip.ms site they have a config guide for IOS 15.1, but I am still running 12.4 and more then a few of the commands do not work for me.

version 12.4

voice service voip
allow-connections sip to sip
registrar server
authentication username XXXXXX password XXXXXX realm chicago.voip.ms
calling-info pstn-to-sip from number set 1XXXXXX0010
no remote-party-id
retry register 10
registrar dns:chicago.voip.ms expires 3600
registrar ipv4: expires 3600 secondary

RE: Voip.ms

Here is some of what I have. Do you the correct interfaces set up (i.e. g0/1 is bound to the service provider and g0/0 is bound to CUCM). Hope this helps.
voice service voip
no ip address trusted authenticate
mode border-element license capacity 25
allow-connections h323 to h323
allow-connections h323 to sip
allow-connections sip to h323
allow-connections sip to sip
redirect ip2ip
signaling forward unconditional
fax protocol pass-through g711ulaw
rel1xx disable
asserted-id pai
asymmetric payload dtmf
early-offer forced
midcall-signaling passthru
privacy-policy passthru

credentials username ##### password 7 ##### realm Realm
authentication username 2507435221 password 7 #####
no remote-party-id
retry invite 2
retry register 10
timers connect 100
registrar ipv4: expires 3600
sip-server ipv4:

RE: Voip.ms


Been rather busy the last week or so. SO slow getting back to you

" Do you the correct interfaces set up (i.e. g0/1 is bound to the service provider and g0/0 is bound to CUCM). Hope this helps."

in short NO.
I was not even using two interfaces, all communications are running from int fa0/0.
Can I just bind loopback interfaces to cucm and the sip provider?

Thanks Much!

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Tek-Tips Forums free from inappropriate posts.
The Tek-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Tek-Tips forums is a member-only feature.

Click Here to join Tek-Tips and talk with other members! Already a Member? Login

Close Box

Join Tek-Tips® Today!

Join your peers on the Internet's largest technical computer professional community.
It's easy to join and it's free.

Here's Why Members Love Tek-Tips Forums:

Register now while it's still free!

Already a member? Close this window and log in.

Join Us             Close