Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
To enable dahdi debugging? 1
- Thread starter hawks
- Start date
-
1
- #2
emtsupport
Vendor
It would depend on the type of DAHDI trunks you have:
If you have Analog FXO trunks the command is core set debug 3
core set debug 0 to turn it off
If you have Digital spans (PRI or T1/E1) then the command is pri set debug on span x
pri set debug off span x to turn it off
for serious d-Channell debuggin you could use pri intense debug span x
pri set debug off span x to turn it off
If you have Analog FXO trunks the command is core set debug 3
core set debug 0 to turn it off
If you have Digital spans (PRI or T1/E1) then the command is pri set debug on span x
pri set debug off span x to turn it off
for serious d-Channell debuggin you could use pri intense debug span x
pri set debug off span x to turn it off
- Thread starter
- #3
thanks emtsupport
I also found this site useful
I also found this site useful
- Status
