×
INTELLIGENT WORK FORUMS
FOR COMPUTER PROFESSIONALS

Contact US

Log In

Come Join Us!

Are you a
Computer / IT professional?
Join Tek-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!

*Tek-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

Octel 350 UDLC failed diagnostic test 20

Octel 350 UDLC failed diagnostic test 20

Octel 350 UDLC failed diagnostic test 20

(OP)
I am getting a UDLC failed diagnostic test 20 on boot up. What is diagnostic test 20?

jtmon

RE: Octel 350 UDLC failed diagnostic test 20

It is one of the internal diagnostic tests. Not much you can do about it except replace the board.

There is a small 3-pin connector on the backplane behind each slot. This is an rs-232 output that you can see the diagnostics from the board when it is booting up. You could try connecting to that and it might tell you which test is failing, but what would you do if it says "DMA error bank0" or some crazy thing?

I don't remember the exact pin out of that 3-pin connector, but one pin is TX, one RX and the other is ground. I believe speed is 9600 with 8 data bits, 1 stop bit and no parity.

RE: Octel 350 UDLC failed diagnostic test 20

(OP)
Thanks for the response. I will give that a try.

RE: Octel 350 UDLC failed diagnostic test 20

Double check the UDLC to make sure none of the chips are out or loose. But more than likely the UDLC is gone unless the slot it is in is bad.

Ken Means

www.tel-is.com
"I find that the harder I work, the more luck I seem to have."
- Thomas Jefferson (1743-1826)

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Tek-Tips Forums free from inappropriate posts.
The Tek-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Tek-Tips forums is a member-only feature.

Click Here to join Tek-Tips and talk with other members! Already a Member? Login

Close Box

Join Tek-Tips® Today!

Join your peers on the Internet's largest technical computer professional community.
It's easy to join and it's free.

Here's Why Members Love Tek-Tips Forums:

Register now while it's still free!

Already a member? Close this window and log in.

Join Us             Close