Hello all, I cleaned the pick-up roller and cleared an obstruction in the top exit slot of my old 8200DP, which apart from the picking up from the paper tray and delivering of duplex prints, was running fine. Now when switched on it's warming up / cleaning to 50%, 60% or more % and then powering off as if disconnected from the power supply. Never done it before. Any solutions / suggestions?
Red Flag Submitted
Thank you for helping keep Tek-Tips Forums free from inappropriate posts. The Tek-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Tek-Tips forums is a member-only feature.