Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Can an out port be set to hi-Z

Status
Not open for further replies.
gibsogu

gibsogu

Programmer
Jan 11, 2013
1
US
I am looking at some old code for an Actel 1280 and see that the author defined a port as an output but then treated it in the code as if it was an inout (never reading it). I have never seen this done before. Is this acceptable? I think it equates to an enabled output buffer. Second question, how would the older generation tools synthesize this?

Thanks ...
 
Status
Not open for further replies.

Similar threads

fig00000
  • Locked
  • Question
Strange reaction in dynamically created textbox and addhandler
Replies
0
Views
510
fig00000
fig00000
isamel85
  • Locked
  • Question
Sending binary data from Matlab to FPGA using the serial port
Replies
0
Views
444
isamel85
isamel85
bravehamid
  • Locked
  • Question
binary to hex Convertor
Replies
0
Views
300
bravehamid
bravehamid
isamel85
  • Locked
  • Question
Digital to analog converter
Replies
0
Views
287
isamel85
isamel85
isamel85
  • Locked
  • Question
Describe in VHDL a generator parallel 4 bits to serial 1 bit
Replies
0
Views
286
isamel85
isamel85

Part and Inventory Search

Sponsor

Back
Top