Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tip #3: SIP setting required for SIP trunks between UCx version 3.0 and CS1000

Status
Not open for further replies.
ucxguy

ucxguy

Programmer
Nov 16, 2011
722
CZ
If you set up SIP trunks between a CS1000 system and a UCx 3.0 system, you may encounter a problem with calls from CS1000 to UCx failing (the message "Your call cannot be completed as dialed. Please check the number and dial again!" is played).

This issue is caused by user option tags added to the destination number by CS1000.

To configure UCx to remove these user option tags, you must add the following "Other SIP Setting" at the bottom of the SIP Settings page:
legacy_useroption_parsing = yes
 
Status
Not open for further replies.

Similar threads

MoJHK
  • Locked
  • Question
Setup a SIP trunk from UCx250 to IPO500V2 errors 1
Replies
7
Views
692
curlycord
curlycord
bb2179
  • Locked
  • Question
I know sip trunks are best effort.
Replies
5
Views
400
curlycord
curlycord
Alfordap
  • Locked
  • Question
UCx SIP trunk to Avaya Session Manager
Replies
7
Views
492
Alfordap
Alfordap
mrdom
  • Question
Time Conditions and Call Flow Control ...
Replies
1
Views
158
ucxguy
ucxguy
ORPG
  • Locked
  • Question
UCx Mini IVR 1
Replies
2
Views
404
ORPG
ORPG

Part and Inventory Search

Sponsor

Back
Top