Switchlady1
Programmer
An ISDN connection on our Nortel System is having a problem dialing out. There is dial tone, however dial tone is constantly heard even after dialing a complete number. Anyone know what might be causing this problem?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
ISDN connection not breaking dial tone
- Thread starter Switchlady1
- Start date
- Status
rerictruax
Vendor
it sounds like the signals for the digits is not being sent over the line to the carrier. Try playing with your D-channel and switch type settings to see if that makes a difference.
One Geek Changing the World
One solution at a time
One Geek Changing the World
One solution at a time
PeterHurst
IS-IT--Management
Indeed - sometimes this can be that you have the device set for overlap when it should be set for en-bloc dialling.
Occasionally it's a problem with older (non-ETSI kit) connecting to newer ISDN (ETSI Compliant) lines.
Occasionally it's a problem with older (non-ETSI kit) connecting to newer ISDN (ETSI Compliant) lines.
Was this once a working system, or is this a new install?
Are we talking PRI or BRI
Has your PBX been upgraded lately?
-------------------------------------------
TIP: If you ask a better question, you will get a better reply. Be specific so we can help!
Are we talking PRI or BRI
Has your PBX been upgraded lately?
-------------------------------------------
TIP: If you ask a better question, you will get a better reply. Be specific so we can help!
- Status
Similar threads
- Locked
- Question
- Locked
- Question
