Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
how to convert anchor points so that they make sharp corners? 1
- Thread starter BobbyBest
- Start date
-
1
- #2
...in the stroke palette you have "miter limit" settings, increase this value until the selected artwork is adjusted correctly...
...the miter values are only active when you have the "miter join" selected in the stroke palette...
andrew
============
============
...the miter values are only active when you have the "miter join" selected in the stroke palette...
andrew
============
============
...also to add to my above post...
...if you later adjust the line, you may find you need to adjust the miter value again, just something to be aware off when making adjustments to paths...
...can catch you out if in a rush, zoomed in and not seeing all the joins in view...
andrew
============
============
...if you later adjust the line, you may find you need to adjust the miter value again, just something to be aware off when making adjustments to paths...
...can catch you out if in a rush, zoomed in and not seeing all the joins in view...
andrew
============
============
- Thread starter
- #4
- Status
Similar threads
- Locked
- Question