HP ProCurve 2910al, Jumbo Frames
HP ProCurve 2910al, Jumbo Frames
(OP)
I have a SAN unit connected through my 2910al switch, I have managed to setup an LACP trunk to get three NICs trunked together and it seems to be working fine. I can't however tell if jumbo frames are enabled where can I look to see if this is set?
The web interface seems a bit poor it currently says LACP States: Disabled, but the CLI shows the LACP trunk as enabled.
Should I also have flow control enabled on the ports carrying the iSCSI traffic?
Thanks.
The web interface seems a bit poor it currently says LACP States: Disabled, but the CLI shows the LACP trunk as enabled.
Should I also have flow control enabled on the ports carrying the iSCSI traffic?
Thanks.
RE: HP ProCurve 2910al, Jumbo Frames
as for flow control, only if your SAN manufacturer says that you should enable it.
I hate all Uppercase... I don't want my groups to seem angry at me all the time! =)
- ColdFlame (vbscript forum)
RE: HP ProCurve 2910al, Jumbo Frames
The easiest way to turn flow control on is to access the switch via a console or telnet and go into the menu (command is menu). From there chose switch config (2) then port / trunk settings. It's fairly simple from there.