I've imported a few BOMs into my MAS90 (Version 4.10.1.18) and all data show up correctly in the system. However, I cannot get a part number on the BOM to show up on Where-Used module. If I manually key in a BOM, then the part number would show up on Where-Used. Any idea why? Did anyone run into issue like this? Any suggestions will be greatly appreciated
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Part numbers on imported BOM does not show up on Where used
- Thread starter annlien
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question