How to find the assigned DDI to an Ext on KX-TDA 1

• Aug 10, 2008

1
• #2

cwc3

Vendor

Feb 17, 2004

2,707

US

in our version of the tda it would be under co setting
did table!

 

Upvote 0 Downvote

• Aug 10, 2008

• Thread starter
• #3

ceil32

MIS

Apr 8, 2008

263

IE

Thanks - what options on the left hand side would that be under

E.g - 4)Extension/Wired extension...

 

Upvote 0 Downvote

• Aug 10, 2008

• #4

cwc3

Vendor

Feb 17, 2004

2,707

US

10> co and call settings > did table on our version, hmm sounds like you were sleeping in the class...

 

Upvote 0 Downvote

• Aug 10, 2008

• Thread starter
• #5

ceil32

MIS

Apr 8, 2008

263

IE

Had there been a class I might have been sleeping - there was no class

 

Upvote 0 Downvote

• Aug 10, 2008

• #6

cwc3

Vendor

Feb 17, 2004

2,707

US

you can't install anything above an 848 here without
passing the factory cert class with an 80 percent....

 

Upvote 0 Downvote

• Aug 10, 2008

• Thread starter
• #7

ceil32

MIS

Apr 8, 2008

263

IE

I didn't install anything - a Panasonic vendor installed it..

 

Upvote 0 Downvote

• Aug 10, 2008

• #8

cwc3

Vendor

Feb 17, 2004

2,707

US

well if an IT person were to try to change programming
on one of my systems it'd void the customers warantee....

 

Upvote 0 Downvote

• Aug 10, 2008

• Thread starter
• #9

ceil32

MIS

Apr 8, 2008

263

IE

System is no longer under warranty and I'm not changing anything - I'm looking to find out existing programming.

 

Upvote 0 Downvote

• Aug 11, 2008

• Thread starter
• #10

ceil32

MIS

Apr 8, 2008

263

IE

The options described above worked perfect - thanks

 

Upvote 0 Downvote