Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

What is Option 176, L2Q=1 for?

Status
Not open for further replies.
Joined
Jan 13, 2006
Messages
293
Location
US
Can someone tell me waht the L2Q=1 parameter is for?

I can't find it in the Lan Admin Guide.
 
? L2Q: setting the 802.1Q framing parameter (1=ON, 2=OFF, or 0=AUTO. The default is 0.)
You can manually set a specific 4600 IP Telephone’s L2Q value to any value other than
AUTO, for example to ON or OFF. However, the telephone uses that manual value rather
than any value administered via the DHCP or TFTP/HTTP settings file. To use the QoS
Local Administrative Option to set L2Q manually see the 4600 Series IP Telephone
Installation Guide.
? L2QVLAN: setting the VLAN ID on which the telephone should operate. For example,
what VLAN ID to use for DHCP Discovery, etc. (up to 4 digits, from 0 to 4094, default is 0).
? VLANTEST: setting the number of seconds to wait for a DHCPOFFER when using a
non--zero VLAN ID (up to 3 digits, from 0 to 999, default is 60).


Greetzzz...Bas

y1pzZTEUdok1vrI5cLb3FdPX4PgTPlSONkb5WPjz0x50etSujaMSmhdRCbOx9vASnrRNzzXv0IxNQA

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________
 
Thanks. I was looking at an old LAN Admin Guide.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top