Text Curve Query
Text Curve Query
(OP)
I am trying to write some text on a curve. I have created an elipse but when I try and put the text on it it will only create it on the outter edge of the elipse. How can I manipulate it so the the text is on the inside of the elipse?
I hope I have explained this correctly!
Cheers
Glenn
I hope I have explained this correctly!
Cheers
Glenn
RE: Text Curve Query
Then just click o.k, in the Text entry box.
----------------------------------
Ignorance is not necessarily Bliss, case in point:
Unknown has caused an Unknown Error on Unknown and must be shutdown to prevent damage to Unknown.
RE: Text Curve Query
I couldn't see the 'Offset' property on my toolbar but I may have messed around with my toolbar when I first set it up. However I couldn't find anything about 'Offset' in the menus either.
RE: Text Curve Query
----------------------------------
Ignorance is not necessarily Bliss, case in point:
Unknown has caused an Unknown Error on Unknown and must be shutdown to prevent damage to Unknown.
RE: Text Curve Query
Now, as you can see from the photo below, the text is up[side down and back to front. Any ideas how can I change this so that is reading the right way up and from left to right?
Cheers
Glenn