I'm a little new to the ScreenOS platform, but here's what I'm trying to do to set up my lab:
I have a PPPoE Connection over DSL connected to my Untrust NIC on the juniper. This hands out one dynamic address as my "primary address" from my ISP and from there I have access to 5 static addresses. So, here's my issue - If i hard wire the DSL modem in to my PC and fire up the PPPoE connection, i can get through to the static addresses. If i connect this into the Juuniper and fire up the PPPoE Connection, the Dynamic address works fine, but I am at a bit of a loss as to how to configure the static addresses to work with this. I have tried using MIPs in the policy, and i can then get to those addresses on the inside of the network, but as soon as I do this, i lose internet connectivity on every machine that uses the MIPs (possible routing issue..)
Does anyone have any thoughts on this? This particular platform does not support the "Alternate IP Addresses" like the bigger boxes do, so that is not an option.
Thanks in advance!
CEH, CISSP, MCSA/MCSE 2000/2003