Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

peidt 1

Status
Not open for further replies.
dixxy

dixxy

Technical User
Mar 4, 2003
220
CA
Hello,

i am having trouble with pedit. What cause line to not want to join together when using the PEDIT command?

I have a bunch lines that i want to join together to create a single polyline, and it's not working. Some of them came together, but the rest won't do it.

Why would this happened?

Thanks,

Sylvain
 
Sort by date Sort by votes
Do the end points of each line 'line up'? I have had this happen where I thought they should line up, but were off by a little bit. If you select one of the lines, click in the endpoint grip, move you mouse and select the end point of the line to which you want to join it, then try the pedit command again.

Kevin Petursson
 
Upvote 0 Downvote
Besides endpoints touching, all line endpoints need to have the same "z" value (be coplanar).

If there are just small gaps that are otherwise acceptable, try using the "pedit" "multiple" "join" procedure, then specify a "fuzz factor" that is greater than the expected gaps.

 
Upvote 0 Downvote
Ok Thanks I will try this

Thanks,

Sylvain
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top