Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Announcement only disconnect
- Thread starter plough
- Start date
Requires Application Builder.
Use the announcement block in appbuilder, record your message and connect the success branch to END block.
On the CP, in the SDN table, place the DN you were using in it and associate it with the application you just built.
On the PBX, create a phantom TN with that same DN you have in the SDN table...have the phantom tn DCFW to CP Main Messaging DN
Use the announcement block in appbuilder, record your message and connect the success branch to END block.
On the CP, in the SDN table, place the DN you were using in it and associate it with the application you just built.
On the PBX, create a phantom TN with that same DN you have in the SDN table...have the phantom tn DCFW to CP Main Messaging DN
- Thread starter
- #3
- Thread starter
- #5
I know I've wanted to do the same thing.- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question