CDP and Not UDP(Loc)
CDP and Not UDP(Loc)
(OP)
Guys, why will my CP Server 703t NMS only work over the network (ITG) by using CDP and not UDP in the DMI (LocationCodes)?
Some of the calls the VM responds with an additonal digit 1 infront of the HLOC+Extn ?
Any ideas that could help me?
Is it a Network Licence Issue?
Cheers
RE: CDP and Not UDP(Loc)
john poole
bellsouth business
columbia,sc
RE: CDP and Not UDP(Loc)
-PNI on route at originating PBX to match PNI in net datablock in destination PBX
-Net datablock prompt AC2 set to LOC
-AC2 has HLOC programmed, with DMI to delete 3 digits
-AC2 has LOCs programmed
-No digit manipulation on outgoing call
-INAC on route set to YES
CallPilot config:
-Message Network config for each site set for ESN. You'll need to put in ESN (AC2) access code, your HLOC, and your VPIM shortcut (usually 1+NPA+NXX overlap 0, but that may vary)
John mentioned checking for VOD and VCE mismatches, probably because of that "1" problem.
And is the ITG programmed as well as the PBX?
RE: CDP and Not UDP(Loc)
Many Thanks Guys will check all that
Cheers Now!!