CALL PILOT DOWN CALL PILOT DOWN scanjet (TechnicalUser) (OP) 29 Apr 06 10:02 MOVED OPTION 11C THEN BROGHT SYSTEM UP BUT I CANNOT GET AUTO ATTENEDENT TO PICK UP.MY PORTS ALL SHOW IDLE LOG INANY HELP WOULD BE APPRECIATEDTHANKS RE: CALL PILOT DOWN sandyml (Vendor) 29 Apr 06 10:05 Is this a 201i? First, shut down CallPilot (Ctl-Alt-Del on monitor keyboard, then Shut Down). When it is down and says "safe to power off," then back it out of the shelf an inch or so. Leave it for a minute, then plug it back in. Let it start up normally. Let me know if that works. RE: CALL PILOT DOWN scanjet (TechnicalUser) (OP) 29 Apr 06 12:22 tried that it still does not boot up but I get these errorswhich seems to be that slot 10 does not get recognizedXMI002 9 MGATEXMI002 10 MGATEXMI007 RE: CALL PILOT DOWN johnpoole (Programmer) 29 Apr 06 18:34 those errors are not bad, just the switch seeing your mgate. might try an ini.. do you see anything on the boot sequence? john poolebellsouth businesscolumbia,sc RE: CALL PILOT DOWN scanjet (TechnicalUser) (OP) 29 Apr 06 23:37 thanks for the help I did the ini to no avail my elan was not connected so I did that and re started call pilot and it came up it seems I should have checked my connections better.