Panisonic 123211 T1 setup, DTMF, Second Dialtone,
2

Question

Panisonic 123211 T1 setup, DTMF, Second Dialtone,

matthuw (ISP)

(OP)

14 Oct 05 12:20

Need to understand how to get DTMF to pass from user station when set up on a T1 line. Also the phone company says they can't provide dialtone, once user is on a CO line. Does anyone know how to set the "wink" timing options.

Thanks
Matthuw

cwc3 (Vendor) · Answer 1 · 2005-10-14 12:30:05

RE: Panisonic 123211 T1 setup, DTMF, Second Dialtone,

cwc3 (Vendor) 14 Oct 05 12:30

t1 on 123211? no wink settings pots lines

cwc3 (Vendor) · Answer 2 · 2005-10-14 12:39:57

you need a cisco csu on the t1 that gives 90volt ringing and
-48volt dc 23ma plain old loop start dialtone if you
are in the usa and trying to connect to a KX-T 123211D

SYQUEST (TechnicalUser) · Answer 3 · 2005-10-16 17:00:16

The 123211 does not support T1!

A CSU does NOT provide ringing, dialtone, loopstart or groundstart ANYTHING!

A channelbank or T1 multiplexer with DS0 capability and the appropriate configuration or module will provide this type of service and more.......

....JIM....

cwc3 (Vendor) · Answer 4 · 2005-10-16 17:32:10

I know I was trying to put the point across to matt
about real dialtone!!
once you have posted you can not go back and edit your post

matthuw (ISP) · Answer 5 · 2005-11-11 09:57:19

Thanks to those who posted. I used to be a Systems engineer for Datatel back in the days. They merged with Case communications and built CSUs and T-1 multiplexers with channel bank capabilities. So I am familure with the lingo and function. We were able to get DTMF to work, but second dial tone is still not working and will not probably without a channel bank/T-1 mux providing it for the T-1 supplied lines.

Thanks again.

cwc3 (Vendor) · Answer 6 · 2005-11-11 11:14:12

mat get a td 1232 and put a t1 card in it and you wont need a channel bank!!

Come Join Us!

Posting Guidelines

Panisonic 123211 T1 setup, DTMF, Second Dialtone,
2