acewarlock
Technical User
I have 1 location that I can't get into though the BCM Manager as the 1st screen won't load, but I can telnet into it, is there any way that i can get into Vmail b telnet to reset a Vmail box password.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
telnet in to Vmail
- Thread starter acewarlock
- Start date
- Status
Try the above substituting your own BCM IP address.
If you are using XP, make sure that you are not blocking pop ups from that site and check you Java installation.
If the screen will not load it is not usually the BCM but the management PC.
NARSBARS
- Thread starter
- #6
acewarlock
Technical User
We were having a T1 problem yesterday but I could get to the 1st screen and logi in callpilot, but today I can't get the 1st screen as it just hangs. There upgradind the T1 to a full T1 tomorrow, maybe then it will work.
mrmarshall
As usual you are correct about the java. I was just covering the basics when you have a BCM access problem.
By using the
login you will get directly to vmail without having to go through the front end.
NARSBARS
As usual you are correct about the java. I was just covering the basics when you have a BCM access problem.
By using the
login you will get directly to vmail without having to go through the front end.
NARSBARS
- Thread starter
- #8
acewarlock
Technical User
I tried this but it didn't work ( but I was abel to reboot the system and when it came back up everything worked. Thanks for the replys.
- Status
Similar threads
- Locked
- Question
- Locked
- Question