I got past the previous hurdle but now i have another issue. I have been told to use trunk type E&M on the the 24 lines of T-1 off of the DTM. They are all set to wink start for signaling. now on my target lines i have one set to the dnis number specified with the test 800 #. I can dial out from any phone but when i try to call in it is always busy. One line of the attendant phone is set for that targeted line and if you hit it says incoming only. I have tried changing some configurations around and i got all calls to come in on the physical lines on the DTM but i was told that was wrong and that the calls should come in on the target line. I am actually a cisco academy educated person so some of these Bcm things have thrown me for a loop. I would apreciate any advice possible. Thank You and have a good weekend.
Red Flag Submitted
Thank you for helping keep Tek-Tips Forums free from inappropriate posts. The Tek-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Tek-Tips forums is a member-only feature.