Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Dead analog ports

Status
Not open for further replies.
btandr

btandr

IS-IT--Management
Joined
Jul 10, 2001
Messages
2
Location
US
For no reason, our 16-port analog card lost dial tone on 9 ports. I rebooted the switch but only 1 got recovered but I still have 8 ports with no dial tone. Any suggestions or info would be appreciated...
 
Sort by date Sort by votes
If this is the last eight on the card. The card has blowen and needs to be replaced.
 
Upvote 0 Downvote
Thanks for replying...It's actually random, ports 2,5,6,7,9,11,12, 14.
 
Upvote 0 Downvote
Hi,
May be something wrong with TTI service on your switch. Try to enter command:
status tti
Have you any active/alarms associated with this board?
Try to observ both sides of the circuit pack for traces of fire.
 
Upvote 0 Downvote
If you run test board. What are the errors that are being returned for this board? Are you using UTP or Teleco. cable?
 
Upvote 0 Downvote
turn tests off on ALL analog boards. They will error 513 all day if they're not turned off.
 
Upvote 0 Downvote
The error 513 means the test #48 wasn't completed successfully. This test checks is the phone set connected to an analog port or not. Useful feature, by the way.
 
Upvote 0 Downvote
Depending upon the age of the board, your telecom vendor may replace it under warranty. And if the new board shows a number of dead ports, then perhaps the problem is deeper. Just a thought... Doug Frith
Accord Communications
 
Upvote 0 Downvote

Analogue boards are prone to blowing since they can take a hammering. It's for this reason that it is recommended to stretch intuity ports out over several boards. Also the boards are not capable of servicing 16 ports simultaneously (capacity issue) which is not great.

Have you tried popping the board out and re-seating it again

Is it always the same ports or does it appear to be more random ?
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

CarlosPrex
  • Locked
  • Question Question
Caller ID on analog phones
Replies
2
Views
507
busster
busster
R
  • Locked
  • Question Question
G450 Analog-test command
Replies
0
Views
517
Red19
R
telm59
  • Locked
  • Question Question
Analog caller ID
Replies
1
Views
581
dialtonebone
dialtonebone
Traveler74
  • Locked
  • Question Question
how to activate and deactivate MTC on an analog phone in Avaya CM?
Replies
1
Views
556
AvayaTier3
AvayaTier3
Juan_Moct
  • Locked
  • Question Question
AVAYA TN793CP PORTS ISSUES
Replies
1
Views
407
lopes1211
lopes1211

Part and Inventory Search

Sponsor

Back
Top