XP Pro Install - Need Help with Dual Boot 1

[kanlite]

I am currently running two sata drives in a striped array (one big HD)and I have installed the a IDE HD onto the primary IDE slot. I am using xp pro. I want two seperate op systems with xp pro on each.
How do I reinstall xp pro onto the IDE HD? I am having issues doing this because I think that during xp pro setup I am being asked to reinstall the s3112 drivers that relate to the sata drives. Detailed instruction would be greatly appreciated.

 

[BernardStewart]

I have 4 drives in a raid 5 configuration and also two other IDE Drives as C and D drives.

XP pro is installed in each.

When you use the XP set up disc it should give you a listing of all dtives and ask which one you want to install to ( from what I recall I only get the request fro the RAID drivers after I have selected the RAID drive to install to so it appears that it may only be seeing the SATA drive) - if your ide disc is not seen then maybe the jumper settings or bios is wrong.

 

[kanlite]

Thanks for the info. At the moment only the ide drive is being seen during setup but I think I have that sorted now. In Disc Manager however, the ide drive is listed as Disc0 and the Sata drives as Disc 1, how do I swap them around?