Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Where have all the good people gone?

Status
Not open for further replies.

DeltaTech

Programmer
Apr 16, 2003
92
MY
I've been changing channels
But I don't see them on the TV show
Where have all the good people gone?

Friends
If any of you are familiar with VB/XML please, please give me a hand with the problem that I am facing.
See -2147221231 Automation error (XML + VB)
Thanks.
[bigcheeks]
 
Please don't get in the habit of multiposting the same problem. Typically, it doesn't draw more attention to your situation, since most of us read both of your posts anyway. Reposting from one forum to a different forum that might be more appropriate can be an exception, but creating a new post that implies that no "good people" are helping you already isn't going to win "friends" for you here. I suggest you quit "changing channels" and refrain in future from looking a gift horse in the mouth.

HTH

Bob
 
I do beg your pardon Mr BobRodes.
There was no malice intended to anyone who responded to the posts, and in particular Tsuji.
The gift horse, as you call it did not work, as if it did, I would not have reposted.
I do regret, however, that despite reading both my posts, you chose not to respond, until this moment. Also, if you had read through the posts, you would have ascertained that Tsuji uses WinME, and therefore your inference that it is not supported by ME is mistaken.
The reference to "good people" comes from a song. It was meant to be humorous. It is not meant to imply that there are no good people on this board, rather it was meant to make those reading it smile or perhaps laugh and forget their tensions for a moment.
Perhaps you have heard of the song, and perhaps you do have a sense of humor?
 
DeltaTech - suggest you read faq222-2244 carefully, especially paragraphs 1 and 2

________________________________________________________________
If you want to get the best response to a question, please check out FAQ222-2244 first.
'If we're supposed to work in Hex, why have we only got A fingers?'
Drive a Steam Roller
 
Well, either you beg my pardon, or you don't. Your post is unclear on the matter. I'll leave that to you to decide, and respond to your substantive (boldface) response in your other thread.

Bob
 
All right, I've responded on your other thread. Sorry to snap at you, pal, but when you say you have no idea what an error means, and I figure it out in less than one minute by the simplest of means, it suggests that you've stopped trying to find the answer. Once you do that, everyone else will follow suit.

HTH

Bob
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top