Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Where do you enable Ports on a Windows 2000 Server?

Status
Not open for further replies.
Internetor

Internetor

IS-IT--Management
Joined
Mar 1, 2003
Messages
3
Location
US
There must be an area where you can specify what ports to use for remote access in Windows 2000 server. This may be the reason for not connecting with a remote PCAnywhere 10.0 client because the port may not be open on the host side. The router's incoming log picks up the request. Note: firewall software on the server is not being used; port forwarding is enabled as is port triggering. What should I troubleshoot on both ends?

Internetor
 
Status
Not open for further replies.

Similar threads

tviman
  • Locked
  • Question Question
Do routers at each end of VPN tunnel need to be the same?
Replies
3
Views
626
tviman
tviman
Bubbalouie
  • Locked
  • Question Question
Looking for a recommendation on a branch router
Replies
6
Views
589
SYQUEST
SYQUEST
lharris1103
  • Locked
  • Question Question
Make a Linksys e2100l Router As a Switch
Replies
5
Views
696
lharris1103
lharris1103
03Explorer
  • Locked
  • Question Question
Tomato on WRT54G with Ooma
Replies
1
Views
293
SYQUEST
SYQUEST
wuzhounet
  • Locked
  • Question Question
Two Public Static IP address
Replies
3
Views
675
goombawaho
goombawaho

Part and Inventory Search

Sponsor

Back
Top