paul3461000
MIS
Can someone tell me waht the L2Q=1 parameter is for?
I can't find it in the Lan Admin Guide.
I can't find it in the Lan Admin Guide.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
What is Option 176, L2Q=1 for?
- Thread starter paul3461000
- Start date
- Status
? L2Q: setting the 802.1Q framing parameter (1=ON, 2=OFF, or 0=AUTO. The default is 0.)
You can manually set a specific 4600 IP Telephone’s L2Q value to any value other than
AUTO, for example to ON or OFF. However, the telephone uses that manual value rather
than any value administered via the DHCP or TFTP/HTTP settings file. To use the QoS
Local Administrative Option to set L2Q manually see the 4600 Series IP Telephone
Installation Guide.
? L2QVLAN: setting the VLAN ID on which the telephone should operate. For example,
what VLAN ID to use for DHCP Discovery, etc. (up to 4 digits, from 0 to 4094, default is 0).
? VLANTEST: setting the number of seconds to wait for a DHCPOFFER when using a
non--zero VLAN ID (up to 3 digits, from 0 to 999, default is 60).
Greetzzz...Bas
___________________________________________
It works! Now if only I could remember what I did...
___________________________________________
You can manually set a specific 4600 IP Telephone’s L2Q value to any value other than
AUTO, for example to ON or OFF. However, the telephone uses that manual value rather
than any value administered via the DHCP or TFTP/HTTP settings file. To use the QoS
Local Administrative Option to set L2Q manually see the 4600 Series IP Telephone
Installation Guide.
? L2QVLAN: setting the VLAN ID on which the telephone should operate. For example,
what VLAN ID to use for DHCP Discovery, etc. (up to 4 digits, from 0 to 4094, default is 0).
? VLANTEST: setting the number of seconds to wait for a DHCPOFFER when using a
non--zero VLAN ID (up to 3 digits, from 0 to 999, default is 60).
Greetzzz...Bas
___________________________________________
It works! Now if only I could remember what I did...
___________________________________________
- Thread starter
- #3
paul3461000
MIS
Thanks. I was looking at an old LAN Admin Guide.
- Status
Similar threads
