I have copied numerous phones over the last few years... I Recently added a New DL Card, and activated it by copying a phone onto TN 16-0 Works fine. Here are the card details;
>ld 32
NPR000
.idc 16
=> NT8D02GA 07 NNTM60G7ZUPU 0000
I tried today to add another phone to this DLC but for some reason it will not take. See below,
REQ: cpy 1
TYPE: 2006
CFTN 13 15
DES 859
*** MAKE PRINTER READY ***
TN 16 1
DN 870
SCH3300
DN
SCH3300 Which in my book states the DN or Position ID is Invalid, it must be unique.
870 is a new unused DN. TN 16-1 is available See below
ld 32
NPR000
.stat 16
00 = UNIT 00 = IDLE (2006)
01 = UNIT 01 = UNEQ
02 = UNIT 02 = UNEQ
03 = UNIT 03 = UNEQ
04 = UNIT 04 = UNEQ......
Did I not properly activate the new Line Card? Am I missing something very obvious? (its been a long day..) or could I have a bad DL Card?
What steps would a pro take to diag this?
Create a New?
Mov an Existing?
Regards,
Steve
>ld 32
NPR000
.idc 16
=> NT8D02GA 07 NNTM60G7ZUPU 0000
I tried today to add another phone to this DLC but for some reason it will not take. See below,
REQ: cpy 1
TYPE: 2006
CFTN 13 15
DES 859
*** MAKE PRINTER READY ***
TN 16 1
DN 870
SCH3300
DN
SCH3300 Which in my book states the DN or Position ID is Invalid, it must be unique.
870 is a new unused DN. TN 16-1 is available See below
ld 32
NPR000
.stat 16
00 = UNIT 00 = IDLE (2006)
01 = UNIT 01 = UNEQ
02 = UNIT 02 = UNEQ
03 = UNIT 03 = UNEQ
04 = UNIT 04 = UNEQ......
Did I not properly activate the new Line Card? Am I missing something very obvious? (its been a long day..) or could I have a bad DL Card?
What steps would a pro take to diag this?
Create a New?
Mov an Existing?
Regards,
Steve