watermarksin crystal reports

[nks]

I am trying to display a water mark in the Crystal report The solution I got is only by using a BMP file through insert Option on the link as follows:

http://support.crystaldecisions.com/kbase/c2005119.asp

I wonder if there is another way of doing it, which does not use a BMP file.

I am actually in urgent need of this information.

 

[Ngolem]

Place the bitmap in a Page header section of the report and in the section editor check off the "Underlay following sections"

Through trial and error you should get it to fit properly

 

[kenhamady]

Crystal supports other image formats, at least the later versions. What do you want to use? Ken Hamady, On-site/Phone Crystal Reports Training/Consulting
Quick Reference Guide to using Crystal in VB

http://www.kenhamady.com/

 

[ydeochakke]

Hi kenhamady

I wanted to know if there is any other way of putting Watermarks on Crystal Reports, other than the - "Underlay following sections" using Bitmap Option.

If I have 100 reports and I want to put a watermark on all those 100 reports, then do I need to create a separate Page Header and Insert a Bitmap for all these report sources...

Isnt there any easy and faster way of doing the same thing.

Regards,
nks/yogesh

 

[kenhamady]

Not that I know of. There is no way to modify multiple reports, automatically. Ken Hamady, On-site/Phone Crystal Reports Training/Consulting
Quick Reference Guide to using Crystal in VB

http://www.kenhamady.com/