Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

VWIC-1MFT-T1 Configuration Help

Status
Not open for further replies.
ciscotroubles

ciscotroubles

MIS
Joined
Dec 3, 2002
Messages
3
Location
US
I am trying to configure a 1751V router that has a VWIC-1MFT-T1 card, and a T1 DSU/CSU card. I am trying to connect to my PBX, but I am not sure on how to set my channels up for voice and data. 1-17 are for voice and 18-24 are for data. Any help is greatly appreciated.
 
Sort by date Sort by votes
I believe the VWIC is setup using the channel-group command and the WIC uses the service-module command.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Jared R
  • Locked
  • Question Question
Cisco UC320W Paging Help
Replies
0
Views
706
Jared R
Jared R
WinstonCH
  • Locked
  • Helpful tip Helpful tip
What is wrong with the diagram, there are people who will help to fix it? How do i do the configurat
Replies
1
Views
925
BIS
BIS
bfordz
  • Locked
  • Question Question
new help on setting up third party VoIP phones through Catalyst 2960x switch
Replies
0
Views
364
bfordz
bfordz
DigiByte34
  • Locked
  • Question Question
Need Help Cisco AAA to any RADIUS Software
Replies
9
Views
929
DigiByte34
DigiByte34
Tariq Habaybeh
  • Locked
  • Question Question
Cisco 881WD-E-K9 router configuration
Replies
1
Views
393
burtsbees
burtsbees

Part and Inventory Search

Sponsor

Back
Top